6 Steps For Effective Gun Cleaning
Step 1. ALWAYS ensure the gun is unloaded and pointed in a secure direction!
Step 2. Fastidiously take gun apart, ensuring to maintain track of all parts. Please reference your homeowners guide for detailed directions on how you can disassemble weapon. For many over/unders, when the action is closed, you remove the forestock (wooden half where your front hand goes beneath the barrel) by pulling down on the lever on the forestock. With the forestock off, you open the action of the gun and pull up and forward on the barrels (be careful not to let the barrels fall off the gun and to the ground once the action is open). You now have three distinct items, the receiver (stock and trigger assembly), the barrels, and the forestock. (Additionally, reference our gun cleaning video to comply with alongside visually).
Step 3. Clear your weapon with a solvent (reminiscent of Hoppe's 9). Inside the barrels, use a bore brush or a rod with a patch with solvent utilized to the patch. (preferable pushing from the breach to the entrance of barrels (the identical direction the shot/slug travels). Then use a clear dry patch and push that patch by the barrels. Continue this alternating process utilizing clear patches (first with solvent and then without) until the patches not come out dirty. Use a toothbrush with solvent to scrub different metal elements of gun to remove gathered residue/deposits/"gunk".
Step 4. Remove any remaining solvent from surfaces. Wipe down the firearm and all of the elements to remove any residual solvent (which if left on metal could be harmful).
Step 5. Wipe down metal components with light coat of oil/lubricant/rust inhibitor. To guard the firearm and help it operate properly, wipe down metal parts with a light coat of gun oil or lubricant akin to silicone or RemLube by Remington. Use the lubricant/oil sparingly. A little bit goes a protracted way. If the storing the gun, try not to go away fingerprints on it. While the fingerprints will probably not do anything to effect the function of the gun, they can be unsightly and the oils in your skin may mar the end of the metal.
Step 6. Reassemble weapon and confirm that it's functioning properly. Holding the receiver horizontal and with the barrels at a forty five degree angle to the ground, slide the barrels down onto/into the receiver till the "hook" on the backside of the barrel(s) catches in the receiver. Lift up on the entrance of the barrels till they lock into place. Now reattach the forestock. With the small latch on the forestock open, copper removal slide the forestock into place and smoothly shut the latch. Then open the breach of the gun and close it again to make sure reassembly was finished correctly. All parts should move smoothly without any extra liquids/oils/and so on seen on any part(s) of the gun. Do NOT use undue power on the weapon. Likelihood is if it's important to use much (if any) muscle, you might be doing something incorrectly.